Name | Location | Locator View | Connector End View |
|---|---|---|---|
Convenience Center | Under the left side of the IP, on the bulkhead | Transfer Case Control Component Views | Power and Grounding Connector End Views in Wiring Systems |
Front Axle Actuator | On the RH side of the front differential | Transfer Case Control Component Views | Transfer Case Control Connector End Views |
IP Fuse Block | To the left of the IP, near the left front door jamb switch | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Powertrain Control Module (PCM) (Diesel) | Under RH end of IP, above Blower Motor, behind IP Compartment Box | Engine Controls Component Views in Engine Controls | Powertrain Control Module Connector End Views in Engine Controls |
Transfer Case Mode Selector Illumination Lamp | In Transfer Case Shift Lever housing | Transfer Case Control Component Views | -- |
Timer Logic and Relay Module | RR of Engine Compartment, near center of Bulkhead | Transfer Case Control Component Views | Transfer Case Control Connector End Views |
Transfer Case Shift Lever | LH side of floor console | Transfer Case Control Component Views | -- |
Transfer Case Switch | Left side of transfer case, behind input shaft, facing toward engine | Transfer Case Control Component Views | Transfer Case Control Connector End Views |
Tranfer Case Synchronizer | Rear of the Transfer Case | Transfer Case Control Component Views | Transfer Case Control Connector End Views |
Vehicle Control Module (VCM) (Gas) | Engine Compartment, near EBCM | Engine Controls Component Views in Engine Controls | VCM Connector End Views in Engine Controls |
4WD Indicator Lamp | In Transfer Case Shift Lever Housing | Transfer Case Control Component Views | Transfer Case Control Connector End Views |
C100 | Part of the engine harness to IP harness, in the left rear side of the engine compartment, at the bulkhead | Transfer Case Control Component Views | Inline Harness Connector End Views in Wiring Systems |
C120 | Part of the engine harness to front axle actuator, in the rear of the engine, near the transmission | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
C210 | At the convenience center | Harness Routing Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
C298 | Behind the left side of the IP, near the convenience center | Harness Routing Views in Wiring Systems | Inline Harness Connector End Views in Wiring Systems |
G105 (Gas) | On the right front side of the engine block | Power and Grounding Component Views in Wiring Systems | -- |
G105 (Diesel) | Right Rear of the cylinder head, cylinder #7 intake bolt | Power and Grounding Component Views in Wiring Systems | -- |
G202 | Behind the left side of the IP, below the fuse block, on the tie bar | Harness Routing Views in Wiring Systems | -- |
P101 | In the right rear side of the engine compartment, at the bulkhead | Harness Routing Views in Wiring Systems | -- |
S111 (7.4L) | Engine harness, approx. 7 cm (2.5 in) from EBCM breakout | -- | -- |
S111 (5.0L, 5.7L) | Engine harness, approx. 10 cm (4 in) from EBCM breakout, toward taillamp harness breakout | -- | -- |
S111 (6.5L) | Engine harness approx. 11 cm (4 in) from EBCM breakout, toward glow plugs | -- | -- |
S147 (Gas) | engine harness, approx. 5 cm (2 in) from EGR valve breakout, toward taillamp harness breakout | -- | -- |
S147(Diesel) | Engine harness, approx. 4 cm (1.5 in) from starter motor solenoid breakout | -- | -- |
S162 (5.0L, 5.7L) | Engine harness, approx. 17 cm (6.5 in) from starter solenoid breakout, toward LH oxygen sensor breakout | -- | -- |
S162 (7.4L) | Engine harness, approx. 15 cm (6 in) from RH bank oxygen sensor breakout, toward starter solenoid breakout | -- | -- |
S217 | IP harness, approx. 16 cm (6 in) from instrument cluster harness breakout, toward radio connectors breakout | -- | -- |
S235 | IP harness, approx. 4 cm (1.5 in) from steering column harness breakout, C100 | -- | -- |
S259 | Crossbody harness, approx. 7 cm (2.5 in) into seat belt switch harness, toward C212 | -- | -- |
S302 | Transfer case harness, approx. 10 cm (4 in) from the transfer case timer logic and relay module breakout, toward the Front Axle Switch | -- | -- |
S314 | Transfer case harness, approx. 5 cm (2 in) from transfer case timer logic and relay module breakout, toward front axle switch | -- | -- |
