Tools Required

J 34940 Rivet Gun

1. Remove the trim panel, as necessary. Refer to Trim Panel Replacement - Rear Door (Cargo Doors) .
2. Remove the water deflector, as necessary. Refer to Water Deflector Replacement .
3. Remove the access hole cover, as necessary. Refer to Access Hole Cover Replacement - Rear Door .



4. Remove the actuator lock control rod (1).
5. Disconnect the actuator wiring connector.
6. Drill out the rivets using an 3 mm (.125 in ) drill bit.
7. Remove the actuator from the door.

1. Using the J 34940 with rivets, install the actuator to the door.
2. Install the actuator lock control rod (1).
3. Connect the actuator wiring connector.



4. Install the water deflector, as necessary. Refer to Water Deflector Replacement .
5. Install the trim panel, as necessary. Refer to Trim Panel Replacement - Rear Door (Cargo Doors) .
6. Install the access hole cover, as necessary. Refer to Access Hole Cover Replacement - Rear Door .