GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 GMC K Pickup - 4WD (CNG) 🢒 Body and Accessories 🢒 Body Rear End 🢒 Pickup Box Replacement

Removal Procedure
  1. Remove the compressed natural gas (CNG) fuel tank, brackets and mounting frame. Refer to CNG Fuel Tank Mounting Frame Replacement .
  2. Remove the pickup box. Refer to Pickup Box Replacement in Body Rear End in the C/K Truck Service Manual.

Installation Procedure
  1. Install the pickup box. Refer to Pickup Box Replacement in Body Rear End in the C/K Truck Service Manual.
  2. Install a protective covering on the floor of the pickup box.

    3. Object Number: 296496 Size: SH
  3. Measure and mark the pickup box floor panel. Verify all the measurements before drilling.
  4. Drill the five holes (1) to 15.88 mm (5/8 in).
  5. Drill the two holes (2) to 25.4 mm (1.0 in).

    6. Object Number: 296497 Size: LH
  6. Align the center hole for the center support bracket (1) with the center hole for the tank mounting frame.
  7. In order to install the center cover support bracket, measure and mark the front pickup box panel. Verify all measurements before drilling.
  8. Drill the three holes (2) to 6.746 mm (17/64 in) diameter.

    9. Object Number: 296499 Size: LH
  9. In order to install the right cover support bracket, measure and mark the front pickup box panel. Verify all measurements before drilling.
  10. Drill the three holes (1) to 6.746 mm (17/64 in) diameter.

    11. Object Number: 296500 Size: LH
  11. Measure and mark the front pickup box panel. Verify all measurements before drilling.
  12. Drill the four holes (1) to 7.177 mm (9/32 in) diameter.

    13. Object Number: 296502 Size: LH
  13. In order to install the left cover support bracket, measure and mark the front pickup box panel. Verify all measurements before drilling.
  14. Drill the three holes (1) to 6.746 mm (17/64 in) diameter.

    15. Object Number: 296503 Size: LH
  15. Measure and mark the front pickup box panel. Verify all measurements before drilling.
  16. Drill the four holes (1) to 7.177 mm (9/32 in) diameter.
  17. Vacuum all metal chips from the pickup box.
  18. Treat each hole with a zinc-rich primer or the equivalent.
  19. Install the compressed natural gas (CNG) mounting frame, brackets and fuel tank. Refer to CNG Fuel Tank Mounting Frame Replacement , CNG Fuel Tank Bracket Replacement - Lower , CNG Fuel Tank Bracket Replacement - Upper and Fuel Tank Replacement .