Tools Required

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief Procedure .
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure .
4. Remove the fuel tank. Refer to Fuel Tank Replacement .

Notice: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the joints.




5. Remove the fuel sender assembly retaining ring using the J 44402 Fuel Tank Sending Unit Wrench.
6. Remove the fuel sender assembly and the seal. Discard the seal.

Caution: Drain the fuel from the fuel sender assembly into an approved container in order to reduce the risk of fire and personal injury. Never store the fuel in an open container.

7. Clean the fuel sender sealing surfaces.

Caution: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket when reinstalling the fuel sender assembly.

1. Install the new seal on the fuel tank.

Important: The fuel pump strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender assembly, assure that the fuel pump strainer does not block full travel of the float arm.

2. Install the fuel sender assembly into the fuel tank.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the fuel sender assembly retaining ring using the J 44402 Fuel Tank Sending Unit Wrench.



4. Install the fuel tank. Refer to Fuel Tank Replacement .
5. Refill the fuel tank.
6. Install the fuel filler cap.
7. Connect the negative battery cable.
8. Inspect for leaks.

8.1.	Turn the ignition switch ON for 2 seconds.

8.2.	Turn the ignition switch OFF for 10 seconds.

8.3.	Turn the ignition switch ON.

8.4.	Check for fuel leaks.