Front Differential Case Disassemble 8.25 Inch

Tools Required

J 22888-D Side Bearing Remover Kit

1. Remove the differential side bearing by performing the following steps:

1.1.	Place the differential case in a vise.





1.2.	Install the J 22888-20A  (2) and the J 8107-2  (1) as shown.

1.3.	Remove the differential side bearings using theJ 22888-20A .

2. Remove the differential assembly from the vise.




Important: The ring gear bolts have left-hand threads.

3. Remove the ring gear bolts. Discard the bolts.




Notice: Do not pry the ring gear from the differential case. Prying the ring gear from the differential case may cause damage to the ring gear and/or the differential case.

4. Remove the ring gear from the differential case.

Drive the ring gear off with a brass drift if necessary.




5. Remove the pinion shaft pin.

Use a hammer and a drift pin in order to drive out the pin.




6. Remove the pinion shaft.



7. Remove the differential pinion gears and the differential side gears by performing the following steps:

7.1.	Roll the differential pinion gears out of the case with the pinion gear thrust washers.

7.2.	Remove the differential side gears and the side gear thrust washers.

Mark the pinion gears and thrust washers top and bottom and the differential side gears and thrust washers left and right.

Front Differential Case Disassemble 9.25 Inch

Tools Required

1. Remove the differential side bearing by performing the following steps:

1.1.	Place the differential case in a vise.





1.2.	Install the J 22888-20A  (2) and the J 36597  (1) as shown.

1.3.	Remove the differential side bearings using theJ 22888-20A .

2. Remove the differential assembly from the vise.




Important: The ring gear bolts have left-hand threads.

3. Remove the ring gear bolts. Discard the bolts.




Notice: Do not pry the ring gear from the differential case. Prying the ring gear from the differential case may cause damage to the ring gear and/or the differential case.

4. Remove the ring gear from the differential case.

Drive the ring gear off with a brass drift if necessary.




5. Remove the pinion shaft lock bolt.



6. Remove the pinion shaft.
7. Remove the differential side gear spacers.



8. Remove the differential pinion gears and thrust washers by performing the following steps:

8.1.	Drive the pinion gear thrust washers out from the differential case using a hammer and a brass drift.

8.2.	Roll the differential pinion gears out of the differential case.

Mark the pinion gears and thrust washers top and bottom.




9. Remove the differential side gears and thrust washers.

Mark the differential side gears and thrust washers left and right.