GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1999 🢒 GMC K Sierra - 4WD 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Steering Column Tilt Head Housing - Assemble - Off Vehicle

Steering Column Tilt Head Housing - Assemble - Off Vehicle Floor Shift

Tools Required

J 23653-SIR Lock Plate Compressor


    Object Number: 330130 Size: SH
  1. Lubricate the following parts with synthetic grease:
    2. • The inner race (1)
    • The lower brass surface of the turn signal cancel cam assembly (4)
  2. Install the following parts onto the steering column shaft assembly:
    3. 2.1. The inner race (1)
    2.2. The upper bearing inner race seat (2)
    2.3. The upper bearing spring (3)
    2.4. The turn signal cancel cam assembly (4)
    2.5. The shaft lock shield assembly (5)

    Object Number: 330127 Size: SH
  3. Compress the shaft lock shield assembly (2) using J 23653-SIR .
  4. Install the new bearing retainer (1) onto the steering column shaft assembly.
  5. Firmly seat the bearing retainer (1) into the groove on the steering column shaft assembly.
  6. Remove J 23653-SIR from the steering column shaft assembly.
  7. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .
  8. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System .

Steering Column Tilt Head Housing - Assemble - Off Vehicle Column Shift

Tools Required

J 23653-SIR Lock Plate Compressor


    Object Number: 330130 Size: SH
  1. Lubricate the following parts with synthetic grease:
    2. • The inner race (1).
    • The lower brass surface of the turn signal cancel cam assembly (4).
  2. Install the following parts onto the steering column shaft assembly:
    3. 2.1. The inner race (1).
    2.2. The upper bearing inner race seat (2).
    2.3. The upper bearing spring (3).
    2.4. The turn signal cancel cam assembly (4).
    2.5. The shaft lock shield assembly (5).

    Object Number: 330127 Size: SH
  3. Compress the shaft lock shield assembly (2) using J 23653-SIR .
  4. Install the new bearing retainer (1) onto the steering column shaft assembly.
  5. Firmly seat the bearing retainer (1) into the groove on the steering column shaft assembly.
  6. Remove J 23653-SIR from the steering column shaft assembly.
  7. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .