GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Was the instrument panel cluster (IPC) system check performed?

--

Go to Step 2

Go to Instrument Cluster System Check

2

  1. Turn the ignition switch to the RUN position.
  2. Remove the combs for the instrument cluster connector.
  3. Backprobe the instrument cluster connector with a J 39200 DMM and measure the voltage between the PNK (39) wire cavity B6 and ground.
  4. Compare the DC voltage reading on the J 39200 DMM and the voltmeter display on the cluster.

Does the cluster and the DMM display the approximately the same values?

--

Go to Instrument Cluster System Check

Go to Step 3

3

Replace the instrument cluster. Refer to Instrument Cluster Replacement .

Is the repair complete?

--

Go to Instrument Cluster System Check

--