Grille Replacement Chevy

1. Open the hood.
2. Remove the upper grille baffle.



3. Rotate the grille retainer 1/4 turn counterclockwise using a Phillips screwdriver.



4. Remove the screw holding the grille to the latch support.



5. Unsnap the grille ends from the fender. Remove the grille from the vehicle.

1. Snap the grille ends into the fender.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




2. Install the screw holding the grille to the latch support.

Tighten
Tighten the screw to 9 N·m (75 lb in).




3. Rotate the grille retainer 1/4 turn clockwise using a Phillips screwdriver.



4. Install the upper grille baffle.
5. Close the hood.
6. Inspect for proper alignment.

Grille Replacement GMC

1. Open the hood.
2. Remove the upper grille baffle.



3. Rotate the grille retainer 1/4 turn counter clockwise using a Phillips screw driver.



4. Remove the screw holding the grille to the latch support.



5. Unsnap the grille end from the fender. Remove the grille from the vehicle.

1. Snap the grille ends into the fender.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




2. Install the screw holding the grille to the latch support.

Tighten
Tighten the screw to 9 N·m (75 lb in).




3. Rotate the grille retainer 1/4 turn clockwise using a Phillips screwdriver.



4. Install the upper grille baffle.
5. Close the hood.
6. Inspect for proper alignment.