Remote Compact Disc Player Replacement I/P Mounted

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Remove the instrument panel trim bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gauges and Console.
3. Use a small screwdriver in order to release the CD player retainers.



4. Remove the electrical connectors.
5. Remove the CD player.

1. Connect the electrical connectors.
2. Install the CD player.
3. When the CD player is fully seated, snap the unit into the retainers.
4. Install the Instrument Panel trim bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gauges and Console.
5. Connect the negative battery cable.
6. Verify the component operation.

Remote Compact Disc Player Replacement Floor Console Mounted

Important: Do not grab or pull on the CD storage door when removing the trim bezel




1. Remove the screws securing the trim bezel to the console extension.
2. Protect the console extension from damage then carefully use a small prying device to push in the tabs underneath the trim bezel securing the top of the trim bezel.
3. Remove the trim bezel.



4. Use a small screwdriver in order to release the CD player retainers.
5. Slide the CD player out . Disconnect the electrical connector.

1. Connect the electrical connector.
2. Install the CD player.
3. When the CD player is fully seated, snap the unit into the retainers.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the trim bezel and the screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

5. Verify the component operation.