Removal Procedure

1. Open the endgate.
2. Remove the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement in Lighting Systems.



3. Remove the striker bolt.

Installation Procedure

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the striker bolt.

Tighten
Tighten the bolt to 50 N·m (37 lb ft).

2. Install the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement in Lighting Systems.
3. Close the endgate.