GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1999 🢒 GMC K Sierra - 4WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Endgate Handle Replacement

Removal Procedure

    Object Number: 366584 Size: SH
  1. Loosen the handle bolts.

    2. Object Number: 366585 Size: SH
  2. Remove the handle bezel by prying gently on the upper snap-in-tabs.

    3. Object Number: 347054 Size: SH
  3. Disengage the linkage rods (1).
  4. Remove the handle bolts.
  5. Remove the handle assembly from the endgate.

Installation Procedure
  1. Position the handle assembly on the endgate.

    2. Object Number: 366584 Size: SH
  2. Install the handle bolts loosely.

    3. Object Number: 347054 Size: SH
  3. Engage the linkage rods (1).

    4. Object Number: 366585 Size: SH
  4. Install the handle bezel.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Tighten the handle bolts.

    6. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).