Tools Required
J 1859-A Steering Wheel Puller
Removal Procedure
- Disable the supplemental inflatable restraint (SIR) system. Refer to
Disabling the SIR System
in SIR.
- Remove the inflator module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
in SIR.
- Remove the horn switch. Refer to
Horn Switch Replacement - On Vehicle
.
- Make an alignment mark in order to note the relationship of the steering
wheel to the steering shaft.
- Remove the steering wheel nut.
- Remove the steering wheel, using the J 1859-A
.
Installation Procedure
- Align the marks made during the removal procedure on the steering shaft
and the steering wheel.
- Install the steering wheel onto the steering
shaft.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the steering wheel nut to the steering shaft.
Tighten
Tighten the nut to 40 N·m (29 lb ft).
- Install the horn switch. Refer to
Horn Switch Replacement - On Vehicle
.
- Install the inflator module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
in SIR.
- Enable the SIR system. Refer to
Disabling the SIR System
in SIR.