For 1990-2009 cars only
Removal Procedure
- If equipped with air conditioning (A/C), set the air flow control to the instrument panel (IP) vent position.
- Apply the parking brake to prevent the vehicle from moving.
- If the transmission is automatic, move the shift lever all the way down.
- Tilt the steering wheel to the full down position.
- Remove the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Remove the end panels. The left panel is shown, and the right panel is similar.
- Remove the right side air outlets.
- Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes.
- Remove the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
- Remove the bolts retaining the panel to IP assembly.
- Lift the trim panel up to disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
- Remove the trim panel from the IP assembly.
Installation Procedure
- Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
- Install the trim panel to the IP assembly.
- Install the trim panel retaining screws.
- Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
- Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
- Install the right side air outlets.
- Install the end panels. The left panel is shown, and the right panel is similar.
- Install the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Tilt the steering wheel to the normal driving position.
- If the transmission is automatic, move the shift lever to the park position.
- Disengage the parking brake.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the trim panel retaining screws to 2 N·m (18 lb in).
