Evaporative Emission Canister Replacement Pickup

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the evaporative emission (EVAP) pipe from the fuel feed/return and EVAP pipe assembly.



3. Disconnect the fuel tank EVAP pipe from the EVAP canister.



4. Disconnect the EVAP pipe from the EVAP canister.



5. Remove the EVAP canister bracket bolt.
6. Remove the EVAP canister.
7. Disconnect the EVAP pipe from the EVAP canister and retaining clip.
8. Remove the EVAP canister from the bracket.

1. Install the EVAP canister to the bracket.
2. Connect the EVAP pipe to the EVAP canister and retaining clip.
3. Install the EVAP canister.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the EVAP canister bracket bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




5. Connect the EVAP pipe to the EVAP canister.



6. Connect the fuel tank EVAP to the EVAP canister.



7. Connect the EVAP pipe to the fuel feed/return and EVAP pipe assembly.
8. Lower the vehicle.

Evaporative Emission Canister Replacement Cab/Chassis

1. Disconnect the fuel tank evaporative emission (EVAP) pipe from the EVAP canister.
2. Disconnect the fuel feed/return and EVAP pipe assembly from the EVAP canister.



3. Disconnect the EVAP vent valve pipe from the EVAP canister.



4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
5. Remove the EVAP canister nuts.
6. Remove the EVAP canister.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the EVAP canister.
2. Install the EVAP canister nuts.

Tighten
Tighten the nuts to 10 N·m (89 lb in).

3. Lower the vehicle.



4. Connect the EVAP vent valve pipe to the EVAP canister.



5. Connect the fuel feed/return and EVAP pipe assembly to the EVAP canister.
6. Connect the fuel tank EVAP pipe to the EVAP canister.