GM Service Manual Online
For 1990-2009 cars only

Product Safety - Body Pressure Relief Valve Sealing

Subject:00092 -- Body Pressure Relief Valve Sealing

Models:1992-2001 Chevrolet and GMC C/K Chassis Cabs (RPO ZW9)



Condition

General Motors has decided that a defect which relates to motor vehicle safety exists in certain 1999-2001 Chevrolet and GMC C/K Chassis Cabs (RPO ZW9). On some of these vehicles either or both of the two body Pressure Relief Valves (PRV) located in the rear of the cab may not seal and may become inoperative during the life of the vehicle if the body installed on the vehicle does not protect the PRVs from road debris. If a PRV does not seal, exhaust fumes could enter into the passenger cab and may cause illness, unconsciousness, or death.

Correction

Dealers are to inspect the vehicle to ensure that the PRV is protected by the body of the vehicle. If the PRV is not protected by the body, dealers are to install a new shielded PRV.

Vehicles Involved

Involved are certain 1999-2001 Chevrolet and GMC C/K Chassis Cabs (RPO ZW9) model vehicles and built within these VIN breakpoints:

Year

Division

Model

Plant

From

Through

1999

GMC

Chassis Cab

Pontiac East

XE500031

XE555844

2000

GMC

Chassis Cab

Pontiac East

YE100716

YE422311

2000

GMC

Chassis Cab

Ft. Wayne

YZ282880

YZ365732

2001

GMC

Chassis Cab

Ft. Wayne

1Z102440

1Z110931

2001

GMC

Chassis Cab

Flint

1F100016

1F100240

1999

Chevrolet

Chassis Cab

Pontiac East

XE100024

XE256529

2000

Chevrolet

Chassis Cab

Pontiac East

YE100042

YE430362

2000

Chevrolet

Chassis Cab

Ft. Wayne

YZ269600

YZ364579

2001

Chevrolet

Chassis Cab

Ft. Wayne

1Z100754

1Z117532

2001

Chevrolet

Chassis Cab

Flint

1F100003

1F100231

Important: Dealers should confirm vehicle eligibility through GMVIS (GM Vehicle Inquiry System) or GM Access Screen (Canada only) or DCS Screen 445 (IPC Only) before beginning campaign repairs. [Not all vehicles within the above breakpoints may be involved.]

Involved vehicles have been identified by Vehicle Identification Number. Computer listings containing the complete Vehicle Identification Number, customer name and address data have been prepared, and are being furnished to involved dealers with the campaign bulletin. The customer name and address data furnished will enable dealers to follow-up with customers involved in this campaign. Any dealer not receiving a computer listing with the campaign bulletin has no involved vehicles currently assigned.

These dealer listings may contain customer names and addresses obtained from Motor Vehicle Registration Records. The use of such motor vehicle registration data for any other purpose is a violation of law in several states/provinces/countries. Accordingly, you are urged to limit the use of this listing to the follow-up necessary to complete this campaign.

Parts Information

Parts required to complete this campaign are to be obtained from General Motors Service Parts Operations (GMSPO). Please refer to your "involved vehicles listing" before ordering parts. Normal orders should be placed on a DRO = Daily Replenishment Order. In an emergency situation, parts should be ordered on a CSO = Customer Special Order.

Part Number

Description

Qty/ Vehicle

15066474

Valve Asm, Body RR Otr Pnl

2 (If Req'd)

Service Procedure


    Object Number: 787507  Size: SH
  1. Measure the distance between the back of the cab and the body (1).
  2.  - If the distance is less than 75mm (3 in), proceed to Step 2.
     - If the distance is greater than 75mm (3 in), proceed to Step 3.

    Object Number: 787511  Size: SH
  3. Inspect to ensure that the truck body shields the entire surface of both of the PRVs (2) by a minimum of 50mm (2 in) on around the bottom and sides (3) of the PRVs. The body must be the same height or higher than the top of the PRVs (1).
  4. PRV Completely Shielded by Body


    Object Number: 787512  Size: SH
     - If the body shields the entire surface of the PRV (1), and the distance between the cab and the truck body is less than 75mm (3 in), no further action is required. Proceed to Step 5.

    PRV NOT Completely Shielded by Body


    Object Number: 787515  Size: SH
     - If the body does not shield the entire surface of the PRV (1), proceed to Step 3.

    Object Number: 787517  Size: SH

    Notice: Do not damage the paint on the cab.

  5. Remove both of the PRVs by carefully prying the valves loose using a flat-bladed tool and discard.
  6. Proper Orientation of PRV


    Object Number: 787518  Size: SH
  7. Install the new PRVs. Firmly press the PRVs into position.
  8. Install the GM Campaign Identification Label.

Campaign Identification Label

FOR US AND IPC

Place a Campaign Identification Label on each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin. Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or a ball point pen.

Put the Campaign Identification Label on a clean and dry surface of the radiator core support in an area that will be visible to people servicing the vehicle. When installing the Campaign Identification Label, be sure to pull the tab to allow the adhesion of the clear protective covering. Additional Campaign Identification Labels for US dealers can be obtained from Dealer Support Material by calling 1-888-549-6152 (Monday-Friday, 8:00 am to 5:00 pm EST). Ask for Item Number S-1015 when ordering.

Additional Campaign Identification Labels for IPC dealers can be obtained from your Regional Marketing Office.

Campaign Identification Label

FOR CANADA

Place a Campaign Identification Label on each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin. Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or a ball point pen.

Put the Campaign Identification Label on a clean and dry surface of the radiator core support in an area that will be visible to people servicing the vehicle. Additional Campaign Identification Labels for Canadian dealers can be obtained from DGN by calling 1-800-668-5539 (Monday-Friday, 8:00 am to 5:00 pm EST). Ask for Item Number GMP 91 when ordering.

Claim Information

Submit a Product Campaign Claim with the information indicated below:

Repair Performed

Part Count

Part No.

Parts Allow

CC-FC

Labor Op

Labor Hours*

Inspect Body PRVs and Install New PRVs, If Necessary

0 or 2

--

**

MA-96

V0607

0.2

* -- For Campaign Administrative Allowance, add 0.1 hours to the "Labor Hours".

** -- The "Parts Allowance" should be the sum total of the current GMSPO Dealer net price plus applicable Mark-Up or Landed Cost Mark-Up (for IPC) for valve assembly, if required, to complete the repair.

Refer to the General Motors WINS Claims Processing Manual for details on Product Campaign Claim Submission.

Customer Notification

FOR US AND CANADA

Customers will be notified of this campaign on their vehicles by General Motors (see copy of customer letter included with this bulletin).

Customer Notification

FOR IPC

Letters will be sent to known owners of record located within areas covered by the US National Traffic and Motor Vehicle Safety Act. For owners outside these areas, dealers should notify customers using the attached suggested dealer letter.

Dealer Campaign Responsibility

FOR US AND IPC (US States, Territories, and Possessions)

The US National Traffic and Motor Vehicle Safety Act provides that each vehicle which is subject to a recall campaign of this type must be adequately repaired within a reasonable time after the customer has tendered it for repair. A failure to repair within sixty days after tender of a vehicle is prima facie evidence of failure to repair within a reasonable time. If the condition is not adequately repaired within a reasonable time, the customer may be entitled to an identical or reasonably equivalent vehicle at no charge or to a refund of the purchase price less a reasonable allowance for depreciation. To avoid having to provide these burdensome remedies, every effort must be made to promptly schedule an appointment with each customer and to repair their vehicle as soon as possible. In the recall campaign notification letters, customers are told how to contact the US National Highway Traffic Safety Administration if the campaign is not completed within a reasonable time.

Dealer Campaign Responsibility

FOR ALL

All unsold new vehicles in dealers' possession and subject to this campaign MUST be held and inspected/repaired per the service procedure of this campaign bulletin BEFORE customers take possession of these vehicles.

Dealers are to service all vehicles subject to this campaign at no charge to customers, regardless of mileage, age of vehicle, or ownership, from this time forward.

Customers who have recently purchased vehicles sold from your vehicle inventory, and for which there is no customer information indicated on the dealer listing, are to be contacted by the dealer. Arrangements are to be made to make the required correction according to the instructions contained in this bulletin. This could be done by mailing to such customers a copy of the customer letter accompanying this bulletin. Campaign follow-up cards should not be used for this purpose, since the customer may not as yet have received the notification letter.

In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.

April, 2001

Dear General Motors Customer:

This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.

Reason For This Recall

General Motors has decided that a defect which relates to motor vehicle safety exists in certain 1999-2001 Chevrolet and GMC C/K Chassis Cabs. On some of these vehicles either or both of the two body Pressure Relief Valves (PRV) may not seal and may become inoperative during the life of the vehicle if the body installed on the vehicle does not protect the PRVs from road debris. If a PRV does not seal, exhaust fumes could enter into the passenger cab and may cause illness, unconsciousness, or death.

What Will Be Done

Your dealer will inspect your vehicle to ensure that the PRVs are protected by the body of the vehicle. If the PRVs are not protected by the body, your dealer will install new shielded PRVs. This service will be performed for you at no charge .

How Long Will The Repair Take?

The length of time required to perform this inspection and service correction, if required, is approximately 15 minutes. Additional time may be required to schedule and process your vehicle. If you dealer has a large number of vehicles awaiting service, this additional time may be significant. Please ask your dealer if you wish to know how much additional time will be needed to schedule, process and repair your vehicle.

Contacting Your Dealer

Please contact your Chevrolet/GMC dealer as soon as possible to arrange a service date. Parts are available and instructions for making this correction have been sent to your dealer.

Your Chevrolet/GMC dealer is best equipped to obtain parts and provide services to correct your vehicle as promptly as possible. Should your dealer be unable to schedule a service date within a reasonable time, you should contact the appropriate Customer Assistance Center at the number listed below:

Division

Number

Deaf, Hearing Impaired, or Speech Impaired*

Chevrolet

1-800-222-1020

1-800-833-2438

GMC

1-800-462-8782

1-800-462-8583

* Utilizes Telecommunication Devices for the Deaf/Text Telephones (TDD/TTY)

If, after contacting the appropriate customer assistance center, you are still not satisfied that we have done our best to remedy this condition without charge and within a reasonable time, you may wish to write the Administrator, National Highway Traffic Safety Administration, 400 Seventh Street SW, Washington, DC 20590 or call 1-888-327-4236.

Customer Reply Card

The attached customer reply card identifies your vehicle. Presentation of this card to your dealer will assist in making the necessary correction in the shortest possible time. If you no longer own this vehicle, please let us know by completing the attached and mailing it in the postage paid envelope.

We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your safety and continued satisfaction with our products.

General Motors Corporation

Enclosure