Removal Procedure
- Lift the vehicle. Refer to Lifting and
Jacking the Vehicle in General Information.
- Remove the oil pan and filter. Refer to
Automatic Transmission Fluid and Filter Replacement.
- Remove the six forward servo cover bolts, cover, and gasket.
- Remove the following parts:
| • | Forward servo piston pin (5) |
Installation Procedure
- Install the following parts:
| • | Forward servo piston pin (5) |
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the six forward servo gasket, cover, and six bolts.
Tighten
Tighten the bolts to 24 N·m (18 lb ft).
- Install the oil pan and filter. Refer to
Automatic Transmission Fluid and Filter Replacement.
- Lower the vehicle.
