For 1990-2009 cars only
Tools Required
| • | J 6116-A Rear Gear Holding Fixture |
| • | J 6129 Handle |
| • | J 21364-A Rear Gear Holding Fixture Adapter |
| • | J 38868 Output Shaft Assembly Remover and Installer |
- Remove the center support bolt (25).
- Remove the rear oil cooler pipe fitting (90).
- Inspect the rear oil cooler pipe fitting (90) for damaged threads.
- Inspect the rear oil cooler pipe fitting seal (91) for nicks or cuts.
- Remove the center support retainer ring (633).
- Attach the J 38868 to the transmission main shaft.
- Tighten the thumb screw on the J 38868 .
- Install the J 6129 to the J 38868 .
- Turn the J 6129 so that the handle shaft contacts the transmission main shaft.
- Remove the center support and gear unit assembly (640-672) by lifting the J 38868 with the J 6129 .
- Remove the J 6129 and the J 38868 .
- Place the center support and gear unit assembly (640-672) into the J 21364-A (not visible in the illustration) and then into the J 6116-A .
Notice: Discard the center support bolt (25) after you have removed the bolt. Damage could result to the center support housing if you reuse the bolt.
Tools Required
| • | J 6116-A Rear Gear Holding Fixture |
| • | J 21364-A Rear Gear Holding Fixture Adapter |
| • | J 38868 Lower Gear Unit Assembly Remover/Installer |
| • | J 6129 Handle |
- Remove the center support bolt (25).
- Remove the rear oil cooler pipe fitting (90).
- Inspect the rear oil cooler pipe fitting (90) for damaged threads.
- Inspect the rear oil cooler pipe fitting seal (91) for nicks or cuts.
- Remove the center support retainer ring (633).
- Attach the J 38868 to the transmission main shaft.
- Tighten the thumb screw on the J 38868 .
- Install the J 6129 to the J 38868 .
- Turn the J 6129 so that the handle shaft contacts the transmission main shaft.
- Remove the center support and gear unit assembly (640-672) by lifting the J 38868 with the J 6129 .
- Remove the J 6129 and the J 38868 .
- Place the center support and gear unit assembly (640-672) into the J 21364-A (not visible in the illustration) and then into the J 6116-A .
Notice: Discard the center support bolt (25) after you have removed the bolt. Damage could result to the center support housing if you reuse the bolt.
