Engine Mount Replacement Front

Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.




1. Raise the vehicle. Support the vehicle with safety stands.
2. Support the engine with a suitable jack. Do not load the engine mounting.
3. Remove the engine mount through-bolt and nut.
4. Raise the engine only enough to permit removal of the engine mount.



5. Remove the engine mount bolts, the nuts, and the washers.
6. Remove the engine mount.

1. Install the engine mount.
2. Install the engine mounting bolts, the nuts, and the washers.




Tighten
Tighten the nut to 41 N·m (30 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Lower the engine until the bolt can be inserted.
4. Install the through-bolt and nut.

Tighten
Tighten the through-bolt to 101 N·m (75 lb ft).

5. Lower the vehicle.

Engine Mount Replacement Rear

Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.




1. Raise the vehicle. Support the vehicle with safety stands.
2. Support the rear of the engine in order to relieve the weight on the rear mount.
3. Remove the rear mount crossmember nuts and washers.
4. Remove the mount-to-transmission bolts and washers.
5. Raise the rear of the engine only enough to allow removal of the mount.
6. Remove the mount.

1. Install the mount.
2. Lower the rear of the engine.
3. Install the mount-to-transmission bolts and washers.
4. Install the mount-to-crossmember nuts and washers.

Tighten
Tighten the fasteners to specifications. Refer to Fastener Tightening Specifications.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Lower the vehicle.