Tools Required

J 23523-F Balancer Remover and Installer

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery negative cable.
2. Remove the fan shroud assembly. Refer to Fan Shroud Replacement in Engine Cooling.
3. Remove the drive belt. Refer to Drive Belt Replacement .



4. Remove the crankshaft balancer. Refer to Crankshaft Balancer Removal .
5. Clean and inspect all of the parts. Refer to Crankshaft Balancer Clean and Inspect .

1. Install the crankshaft balancer. Refer to Crankshaft Balancer Installation .
2. Install the drive belt. Refer to Drive Belt Replacement .
3. Install the fan shroud assembly. Refer to Fan Shroud Replacement in Engine Cooling.
4. Connect the battery negative cable. Refer to Battery Cable Replacement in Engine Electrical.