Notice: Do not run the engine without the oil pump drive in place. This will cause extensive engine damage.

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.



2. Remove the fuel filter from the lower intake manifold. Move the filter out of the way and secure the filter. Refer to the appropriate procedure in Engine Controls:

•	Fuel Manager/Filter Replacement

•	Fuel Manager/Filter Replacement

3. Tie the extension harness assembly on the engine wiring harness out of the way.



4. Remove the retaining bolt from oil pump drive clamp.
5. Remove the oil pump drive clamp.



6. Remove the oil pump drive.
7. Remove the gasket.

1. Install the new gasket to the oil pump drive.
2. Install the oil pump drive to the engine.

•	Index the drive with the camshaft gear and the oil pump drive shaft.

•	Ensure that the oil pump drive seats fully.





Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the oil pump retaining clamp and the bolt to the engine block.

Tighten
Tighten the bolt to 42 N·m (31 lb ft).

4. Untie and reposition the extension harness assembly.



5. Install the fuel filter to the lower intake manifold. Refer to the appropriate procedure in Engine Controls:

•	Fuel Manager/Filter Replacement

•	Fuel Manager/Filter Replacement

6. Connect the negative battery cable.