For 1990-2009 cars only
Removal Procedure
- Disconnect the crankcase vent tube from the rear intermittent duct.
- Loosen the rear intermittent duct clamps and remove.
- Remove the air duct fastner and duct.
- Remove the accelerator cable from the from the throttle pulley.
- Remove the cable from the accelerator cable bracket by releasing the accelerator cable retainer locking tangs.
- Remove the accelerator cable end from the accelerator pedal lever.
- Remove the accelerator cable from the dash panel.
Installation Procedure
Important: Observe the following when installing the accelerator cable in order
to insure the proper operation of the accelerator controls:
• Replace the accelerator cable with an identical replacement part. • Do not route the accelerator cable within 13 mm (0.52 in)
at any point of travel of wires, cables, hoses or other flexible components. • The accelerator controls operate without binding between closed
throttle and wide open throttle position.
- Insert the accelerator cable through the dash panel until the locking tangs are fully seated and locked into position.
- Install the accelerator cable to the accelerator pedal lever.
- Insert the accelerator cable through the accelerator cable support until the locking tangs are fully seated and locked into position.
- Insert the accelerator cable into the throttle pulley slot and groove.
- Install the air duct and duct fastner.
- Install the rear intermittent duct.
- Install the crankcase vent tube to the rear intermittent duct.
- With the engine OFF, check to see that the accelerator pedal does not bind.
Important: Do not twist or kink the accelerator cable in order to insure the cable is properly seated in the throttle pulley groove.
Tighten
tighten the fastner to 2.5N·m(22 lb. in.).
