If an injection nozzle does not deliver fuel properly into the pre-combustion chamber of a cylinder, driveability may greatly affected, or a DTC may set. If the injection nozzles are suspected of not properly delivering fuel, they should be tested. Typically, a nozzle failure can be detected by using the injector balance test.

Nozzle testing is comprised of the following checks:

An injector balance test is performed with the scan tool. This test will properly identify a stuck closed or a noisy injector nozzle. Typically, a nozzle failure will fall into this criteria.

1. Install the scan tool.
2. Start the engine.
3. Allow the engine to idle.
4. Perform the injector balance test on each cylinder (a balance test refers to a specific cylinder).

If a suspect nozzle is located, switch the nozzle to the adjacent cylinder, and repeat the balance test to positively identify the malfunctioning nozzle.

5. Locate and replace the malfunctioning nozzle and the glow plug. Refer to Injection Nozzle(s) Replacement and Glow Plug Replacement - Left Side or Glow Plug Replacement - Right Side .

Caution: Do not place your hands or arms near the tip of the nozzle when testing the nozzles. The high pressure atomized fuel spray from a nozzle has sufficient penetrating power to puncture flesh and destroy tissue. This may result in blood poisoning. Always enclose the nozzle tip in a receptacle, preferably transparent, in order to contain the spray.

Important: The Injector Nozzle Opening Pressure and Leakage tests should be performed only on vehicles with high mileage, engines that have been over-heated, or vehicles that pull heavy loads. False or inaccurate readings can occur if the following tests are not performed to the above criteria.

Important: Each test should be considered independent of the others (for example, when checking the opening pressure, do not check for leakage). If all of the following tests are satisfied, the nozzle assembly can be reused. If any one of the tests is not satisfied, the complete nozzle assembly must be replaced. Refer to Injection Nozzle(s) Replacement .When performing the injection nozzle tests, refer to the instructions provided with the nozzle tester J 29075- B.

1. Open the shutoff valve at the pressure gauge one-quarter turn.
2. Depress the tester lever slowly. Note at what pressure the needle of the pressure gauge stops. The maximum observed pressure is the opening pressure. Some nozzles may pop while other nozzles may drip down (this is not leakage).
3. The opening pressure should not fall below the lower limit of 105 bar (1500 psi) for naturally aspirated engines and 117 bar (1700 psi) for turbo-charged engines for used nozzles.
4. Replace all nozzles that fall below the lower limit. Refer to Injection Nozzle(s) Replacement .

Caution: When testing nozzles, do not place your hands or arms near the tip of the nozzle. The high pressure atomized fuel spray from a nozzle has sufficient penetrating power to puncture flesh and destroy tissue and may result in blood poisoning. The nozzle tip should always be enclosed in a receptacle, preferably transparent, to contain the spray.

Important: The Injector Nozzle Opening Pressure and Leakage tests should be performed only on nozzles with high mileage, engines that have been over-heated, or on vehicles that pull heavy loads. False or inaccurate readings can occur if the following tests are not performed to the above criteria.

1. Open the shutoff valve at the pressure gauge (one turn).
2. Blow dry the nozzle tip.
3. Slowly depress the lever of the manual test stand until the gauge reads a pressure of 95 bar (1400 psi).
4. Observe the nozzle tip. A drop may form on the end of the nozzle but should not drop off within a period of 10 seconds.
5. Replace the nozzle assembly if a drop falls during the 10 seconds. Refer to Injection Nozzle(s) Replacement .