Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.

Caution: To avoid being burned, do not remove the radiator cap or surge tank cap while the engine is hot. The cooling system will release scalding fluid and steam under pressure if radiator cap or surge tank cap is removed while the engine and radiator are still hot.

2. Relieve the cooling system pressure.
3. Drain the cooling system below the level of the sensor. Refer to Draining and Filling Cooling System in Engine Cooling.



4. Disconnect the ECT sensor harness connector.



5. Remove the ECT sensor.

1. Coat the threads (only) with sealer P/N 9985253 or equivalent.




Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

2. Install the ECT sensor.

Tighten
Tighten the ECT sensor to 13 N·m (10 lb ft).




3. Connect the ECT sensor harness connector.
4. Refill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
5. Connect the negative battery cable.