Actuator Motor P92

1. Remove the cable retainer and the actuator cable from the stud on the throttle arm.
2. Remove the two nuts, the clamp and the cable from the mount.

Mark the position of the clamp on the cable for reinstallation.

3. Disconnect the wiring harness electrical connector.

Important: The actuator motor is installed by the coach manufacturer. Refer to the coach manufacturer's service manual for the location of the actuator motor.

4. Remove the four screws and the actuator from the mounting bracket.

1. Install the actuator on the mounting bracket with the four screws.
2. Connect the electrical connector to the wiring harness.
3. Install the cable on the mount with the clamp and the two nuts.

•	The cable must be mounted in the same relative position as before removal.

•	The clamp must be flat so that the cable is held in place with the proper pressure.

•	If installing a new actuator motor and cable assembly, the clamp must hold the cable in the same place as the old cable.

4. Install the cable end on the stud with a new cable retainer.