Important: Before clearing any DTCs, use the Scan Tool Capture Info to save freeze frame and failure records for reference, as the Scan Tool loses data when using the Clear Info function.

Was the Powertrain On-Board Diagnostic (OBD) System Check performed?

--

Go to Step 2

Go to A Powertrain On Board Diagnostic (OBD) System Check

Are there any other DTCs set (all other DTCs must be diagnosed before proceeding on)?

--

Go to the applicable DTC

Go to Step 3

Important: The new PCM must be programmed.

Replace the PCM. Refer to PCM Replacement/Programming .

Is the action complete?

--

Go to Step 4

--

1. Using the Scan Tool, clear the DTCs.
2. Start engine and idle at normal operating temperature.
3. Select DTC, Specific, then enter the DTC number which was set.
4. Operate the vehicle, within the Conditions for Setting this DTC, until the Scan Tool indicates the diagnostic Ran.

Does the Scan Tool indicate the diagnostic Passed?

--

Go to Step 5

Go to Step 2

Does the Scan Tool display any additional undiagnosed DTCs?

--

Go to the applicable DTC table

System OK