Subject: | Rattle in Floor Console Cupholder Door (Add Felt Washer) |
Models: | 2003 Cadillac Escalade, Escalade EXT |
| 2003 GMC Sierra Denali, Yukon Denali, Yukon XL Denali |
| with Luxury Package (RPO Y91) and Custom Front Floor Compartment (RPO
D07) |
Condition
Some customers may comment on a rattle or squeak noise coming from the
front floor console area.
Cause
The lower bezel of the front floor console cupholder door may have too
much lateral movement, causing an intermittent rattle noise.
Correction
Add a new 1 mm (0.04 in) felt washer to the passenger
side pivot point of the cupholder door (1). There will be two felt
washers after the addition of this washer. This should aid in reducing the
rattle noise. Use the following procedure and the part number below.
- Remove the IP cluster bezel. Refer to the Bezel Replacement -
Instrument Panel (I/P) Cluster Replacement procedure in the Instrument Panel,
Gauges and Console sub-section of the Service Information (SI).
- Remove the floor console upper bezel. Detach the harness connector.
Refer to the Bezel Replacement - Floor Console Luxury Upper Replacement procedure
in the Instrument Panel, Gauges and Console sub-section of the Service Information
(SI).
- Remove the floor console lower bezel. Detach the harness connector.
- Remove the nut, the metal washer and the plastic washer from the
pivot point of the passenger side cupholder door.
- Install a new felt washer, P/N 15197151,
over the existing felt washer at the pivot point area shown. Ensure that the
washer is centered so that the door does not bind.
- Install the plastic washer, the metal washer and the nut on the
pivot point of the cupholder door.
- Attach the harness connector at the console lower bezel and install
the bezel.
- Attach the harness connector at the console upper bezel and install
the bezel. Refer to the Bezel Replacement - Floor Console Luxury Upper Replacement
procedure in the Instrument Panel, Gauges and Console sub-section of the Service
Information (SI).
- Install the IP cluster bezel. Refer to the Bezel Replacement -
Instrument Panel (I/P) Cluster Replacement procedure in the Instrument Panel,
Gauges and Console sub-section of the Service Information (SI).
- Reset the clock.
Parts Information
Part Number
| Description
| Qty
|
15197151
| Washer-F/Flr Cnsl (Felt)
| 1
|
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation
| Description
| Labor Time
|
C2085
| Cupholder, Instrument Panel - R or Replace
| 0.2 hr
|