GM Service Manual Online
For 1990-2009 cars only

The SIR Scan Tool Data List contains all restraint system related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The column "Data List," indicates the location of the parameter within the scan tool menu selections.

Use the SIR Scan Tool Data List as directed by a diagnostic table or to supplement the diagnostic procedures. Begin all of the diagnostic procedures with the Diagnostic System Check - SIR. Refer to the Diagnostic System Check - SIR . Use the SIR Scan Tool Data List after determining the following:

    • There are no published DTC procedures nor published symptom procedures for the customer concern.
    • The DTC or symptom diagnostic procedure indicated by the Diagnostic System Check - SIR does not resolve the customer concern.

The Typical Data Values are obtained from a properly operating vehicle under the conditions specified in the first row of the Scan Tool Data List table. Comparison of the parameter values from the suspect vehicle with the Typical Data Values may reveal the source of the customer concern.

Scan Tool Parameter

Data List

Units Displayed

Typical Data Value

Ignition ON/Engine OFF/Driver Seat Belt BUCKLED

8-Digit GM Part Number

Module Information 2

8-digit number

XXXXXXXX

Active Switch

Inputs

Enabled/Disabled

Enabled

Calibration ID

Module Information 1

4-digit number

Varies

Component Serial Number

Module Information 2

Numbers

XXXX

Front End Sensor #1 ID

Module Information 1

2-digit number

Varies

Front End Sensor #2 ID

Module Information 1

2-digit number

Varies

Ignition Voltage

Data

Volts

12 V

Julian Date of Build

Module Information 1

3-digit number

Varies

Driver Seat Belt Status

Inputs

Buckled/Unbuckled

Buckled

Passenger Side Impact Sensor ID

Module Information 1

2-digit number

Varies

ROM ID

Module Information 1

4-digit number

Varies

Year Module Built

Module Information 1

4-digit number

Varies