Removal Procedure
- Unsnap the intake manifold sight shield from the stud.
- Remove the sight shield from the sight shield bracket.
- Remove the sight shield bracket retainer nuts (1), if necessary.
- Remove the sight shield bracket from the studs (2), if necessary.
Installation Procedure
- Install the sight shield bracket to the studs (2), if necessary.
- Install the sight shield bracket nuts (1), if necessary.
- Install the intake manifold sight shield to the bracket.
- Snap the intake manifold sight shield onto the stud.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 5 N·m (44 lb in).
Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
