Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .



2. Unsnap the positive battery cable cap.
3. Disconnect the positive battery cable.



4. Remove the front end diagonal brace bolts and brace.



5. Remove the battery hold down retainer bolt and retainer.
6. Remove the battery.
7. Remove the battery insulator, if necessary.

1. Install the battery insulator, if necessary.
2. Install the battery.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the battery hold down retainer and bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




4. Install the front end diagonal brace and bolts.

Tighten
Tighten the bolts to 9 N·m (80 lb in).




5. Connect the positive battery cable.

Tighten
Tighten the bolt to 17 N·m (13 lb ft).

6. Snap the positive battery cable cap closed.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .