Test Description
Water contamination in the fuel system may cause driveability conditions such
as hesitation, stalling, no start, or misfires in one or more cylinders. Water may
collect near a single fuel injector at the lowest point in the fuel injection system
and cause a misfire in that cylinder. If the fuel system is contaminated with water,
inspect the fuel system components for rust or deterioration.
Ethanol concentrations of greater than 10 percent in nonblended gasoline,
or greater than 85 percent with E85 blended gasoline for flexible fuel applications,
can cause driveability conditions such as hesitation, lack of power, stalling, or
a no start, and may contribute to fuel system corrosion, deterioration of fuel system
components, and a restricted fuel filter.
Reference Information
Special Tool
J 44175 Fuel Composition Tester
System Verification
The fuel sample should be drawn from the bottom of the tank so that any water
present in the tank will be detected. The sample should be bright and clear.
⇒ | If the sample appears cloudy, or contaminated with water, as indicated by
a water layer at the bottom of the sample, perform the Particulate Contaminants in
Fuel Testing Procedure. |
⇒ | If alcohol contamination is suspected, perform the Alcohol in Fuel Testing
procedure. |
Alcohol in Fuel Testing with Special Tool
- Test the fuel composition using
J 44175
and Instruction Manual.
- If water appears in the fuel sample, clean the fuel system.
- Subtract 50 from the reading on the DMM in order to obtain the
percentage of alcohol in the fuel sample.
- If the nonblended gasoline fuel sample measures more than 15 percent
ethanol, or if the E85 blended gasoline fuel sample measures more than 91 percent
ethanol, add fresh regular gasoline to the vehicles's fuel tank.
- Test the fuel composition.
- If additional testing indicates that the ethanol percentage is still above
15 percent for a nonblended gasoline sample, drain and replace the vehicle's
fuel. Refer to
Fuel Tank Draining . If additional testing indicates that
the E85 blended gasoline sample still measures above 91 percent, continue adding
fresh, regular gasoline until the ethanol content is 85 percent or less.
Alcohol in Fuel Testing without Special Tool
- Using a 100 ml (3.38 oz) specified cylinder with 1 ml
(0.034 oz) graduation marks, fill the cylinder with fuel to the 90 ml
(3.04 oz) mark.
- Add 10 ml (0.34 oz) of water in order to bring the total
fluid volume to 100 ml (3.38 oz) and install a stopper.
- Shake the cylinder vigorously for 10-15 seconds.
- Carefully loosen the stopper in order to release the pressure.
- Re-install the stopper and shake the cylinder vigorously again for 10-15 seconds.
- Put the cylinder on a level surface for approximately 5 minutes
in order to allow adequate liquid separation. If alcohol is present in the fuel, the
volume of the lower layer, which would now contain both alcohol and water, will be
more than 10 ml (0.34 oz). For example, if the volume of the lower layer
is increased to 15 ml (0.51 oz), this indicates at least 5 percent
alcohol in the fuel. The actual amount of alcohol may be somewhat more because this
procedure does not extract all of the alcohol from the fuel.
Particulate Contaminants in Fuel Testing Procedure
- Using an approved fuel container, draw approximately 0.5 liter
(0.53 qt) of fuel.
- Place the container on a level surface for approximately 5 minutes
in order to allow settling of the particulate contamination. Particulate contamination
will show up in various shapes and colors. Sand will typically be identified by a
white or light brown crystals. Rubber will appear as black and irregular particles.
- Observe the fuel sample. If any physical contaminants or water are present,
clean the fuel system.
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic procedure.
Fuel System Cleaning