Important:
• Only use oil free compressed air to blow out the fuel pipes. • Inspect the fuel tank internally and clean the fuel tank if you find a plugged fuel filter.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
- Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
- Inspect the fuel strainer. Replace a contaminated strainer and inspect the fuel pump.
- Inspect the fuel pump inlet for dirt and debris. Replace the fuel pump if you find dirt or debris in the fuel pump inlet.
- Flush the fuel tank with hot water.
- Pour the water out of the sending unit opening. Rock the tank to be sure that removal of the water from the tank is complete.
- Install the sending unit. Refer to Fuel Sender Assembly Replacement .
Important: When flushing the fuel tank, handle the fuel and water mixture as a hazardous material. Handle the fuel and water mixture in accordance with all applicable local, state, and federal laws and regulations.
