Removal Procedure
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- If the vehicle is a 1500 series, remove the transfer case shield bolts, if equipped.
- Remove the transfer case shield, if equipped.
- If the vehicle is a 2500 series, remove the transfer case shield screws, if equipped.
- Remove the transfer case shield, if equipped.
Installation Procedure
- If the vehicle is a 2500 series, position the transfer case shield, if equipped.
- Install the transfer case shield screws, if equipped.
- If the vehicle is a 1500 series, position the transfer case shield, if equipped.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the transfer case shield bolts, if equipped.
Tighten
Tighten the bolts/screws to 20 N·m (15 lb ft).
- Lower the vehicle.