Outside Rearview Mirror Glass Replacement DL3, DR4, DL8, 5M1
Removal Procedure
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Notice: When servicing electrochromic glass that is broken, or if glass breaks during
servicing, be cautious not to spill electrochromic fluid onto vehicle.
Doing so will cause damage to the vehicle.
- Adjust mirror face as shown in picture to
obtain access to mirror face retention clips (1).
- Position a flat-bladed tool between back side of mirror face and the adjuster
mechanism as shown in picture.
- With a twisting motion of the flat bladed tool, separate the mirror face
from the adjuster mechanism by releasing the mirror face retention clips (1).
- With mirror face in hand, disconnect the electrical connectors.
- Remove the mirror face from the mirror housing.
- Inspect the adjuster mechanism for damage.
Installation Procedure
- Inspect
the components for any damage. Ensure that the mirror face has all the retention clips
in place.
- Plug in the electrical connectors to the back of the mirror.
- Align the mirror face retention clips with the adjuster mechanism.
- Gently
press the mirror back into the adjuster mechanism with the palm of the hand on the
center of the glass until it locks into place.
- Inspect the operation of the mirror.
Outside Rearview Mirror Glass Replacement 6P3
Removal Procedure
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Notice: When servicing electrochromic glass that is broken, or if glass breaks during
servicing, be cautious not to spill electrochromic fluid onto vehicle.
Doing so will cause damage to the vehicle.
- Adjust the mirror face fully upward in order to
access the mirror retaining tab (4).
- Position a flat-bladed tool between the back side of the mirror face and
the mirror housing at the notch in the mirror face.
- Depress the tab (4) on the back of the mirror face outward using
the flat-bladed tool, while sliding the mirror face upward.
- Slide the mirror face upward to release the mirror face from the mirror
motor retaining tabs (1).
- With the mirror face in hand, disconnect the electrical connectors (2).
- Remove the mirror face from the mirror housing.
Installation Procedure
- Connect the electrical connectors (2) to the
back of the mirror (3).
- Align the mirror motor retaining tabs (1) to the keyhole slots
on the back of the mirror face.
- Insert the motor retaining tabs to the keyhole slots on the mirror face.
- Slide the mirror face downward until the retaining clip (4) latches.
- Adjust the mirror face ensuring the mirror motor tabs are fully engaged
in the keyhole slots on the back of the mirror and the retaining tab (4) is
engaged.