Removal Procedure
- Remove the manual transmission. Refer to the following:
- Remove the clutch release bearing.
• | Rotate the bearing in either direction. |
• | The compression spring load will push the release bearing off the end of the clutch actuator bearing. |
Installation Procedure
Important: DO NOT use cleaners or chemicals to clean the quill and DO NOT grease the quill.
- Using a clean dry cloth, clean the exposed area of the actuator cylinder quill.
- Install the NEW clutch release bearing to the clutch actuator cylinder.
• | Firmly push the clutch release bearing into place. |
• | The release bearing will snap over the retainer tab and will be self-retained to the actuator cylinder. |
- Install the manual transmission. Refer to the following: