Caution: To avoid personal injury to the occupants of the vehicle, observe the
following precautions:
• | More than one supplier's seat belts are used, therefore, install
ONLY the seat belt components specified in the GM parts catalog. |
• | To verify that the correct seat belt components were installed,
insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released. |
Removal Procedure
- Move the front seat to the full forward position.
Important: Do not remove the seat back cover from the head restraint retainers.
- Remove the seat back cover and pad. Refer to
Front Seat Back Cushion Cover and Cushion Pad Replacement
.
- Separate the seat foam from the cardboard to gain access to the retainer on the seat belt side.
- Remove the seat belt side cardboard retainers.
- Move the cardboard outwards to gain access to the lower seat belt retractor bolt.
- Remove the retractor bolt.
- Remove the retractor tower retaining screw.
- Remove the retractor tower cover.
- Remove the upper anchor bolt.
- Remove the retractor from the seat.
Installation Procedure
- Position the seat belt retractor onto the seat.
Line up the tab on the retractor to the tab on the seat frame.
Notice: Refer to Fastener Notice in the Preface section.
- Install the upper anchor bolt.
Tighten
Tighten the bolt to 53 N·m (39 lb ft).
- Install the retractor tower cover.
- Install the retractor tower cover retaining screw.
Tighten
Tighten the screw to 2 N·m (18 lb in).
- Install the retractor.
- Install the retractor bolt.
Tighten
Tighten the bolt to 53 N·m (39 lb ft).
- Install the rear cardboard panel retainers.
- Install the seat back cover and pad. Refer to
Front Seat Back Cushion Cover and Cushion Pad Replacement
.
- Move the seat to its original position.