• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | High Resistance | Open | Short to Voltage | Signal Performance |
---|---|---|---|---|---|
Solenoid Supply Voltage | P0088, P0090 | P0088 | P0090 | P0087, P0191 | -- |
Solenoid Control | P0088, P0090 | P0088 | P0090 | P0090 | -- |
High pressure fuel is regulated by the fuel rail pressure (FRP) regulator mounted on the fuel injection pump. The FRP regulator is controlled by the engine control module (ECM). The FRP regulator has a solenoid supply voltage circuit and solenoid control circuit. The ECM monitors the current on the circuits to detect a failure .
• | The ignition is ON. |
• | The commanded FRP regulator current is between 64-1,500 mA. |
The FRP regulator circuit current is not between 50-1,600 mA.
DTC P0090 is a Type A DTC.
DTC P0090 is a Type A DTC.
• | There are no driveability concerns associated with the FRP regulator unless a DTC is present. The most likely cause of this DTC is a sticking FRP regulator. |
• | If the fuel system pressure is actually too high, a fuel knock and smoke condition will exist. |
• | If the fuse that supplies voltage to terminal C1-76 of the ECM is open, this DTC will set. |
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
• | CH-48027 Digital Pressure Gage |
• | J 35616-200 Test Light Probe Kit |
Important: If you cannot duplicate the condition, operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Important: Failure to allow the ECM communications to completely terminate with the scan tool may result in misdiagnosis.
If DTC U0105, P0087, or P0088 are also set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
Important: A solenoid control circuit that is shorted to voltage will illuminate the test lamp on both the supply voltage circuit and the solenoid control circuit.
⇒ | If the test lamp illuminates , test the solenoid control circuit for a short to voltage. If the circuit tests normal, replace the ECM. |
⇒ | If the test lamp did not illuminate, test the solenoid supply voltage circuit for an open. If the circuit tests normal, replace the ECM. |
⇒ | If the test lamp did not illuminate, test the solenoid control circuit for an open. If the circuit tests normal, replace the ECM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.