Master Cylinder Replacement Hydraulic Boost
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in the Preface section.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.
- Apply the park brake and block the wheels.
- Disconnect the electrical connector from the brake fluid level sensor.
Important: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
- Disconnect the brake pipes from the master cylinder.
- Plug the open brake pipe ends.
- Remove the master cylinder mounting nuts.
- Remove the master cylinder from the vehicle.
- Remove the master cylinder reservoir. Refer to
Master Cylinder Reservoir Replacement
.
Installation Procedure
- Install the master cylinder reservoir. Refer to
Master Cylinder Reservoir Replacement
.
- Bench bleed the master cylinder. Refer to
Master Cylinder Bench Bleeding
.
- Install the master cylinder to the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the master cylinder mounting nuts.
Tighten
Tighten the nuts to 33 N·m (24 lb ft).
- Remove the rubber cap or plug from the exposed brake pipe fitting ends.
- Connect the brake pipes.
Tighten
Tighten the pipe fittings to 25 N·m (18 lb ft).
- Connect the electrical connector to the brake fluid level sensor.
- Bleed the hydraulic brake system. Refer to
Hydraulic Brake System Bleeding
.
- Release the park brake and unblock the wheels.
Master Cylinder Replacement Vacuum Boost
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in the Preface section.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.
- Apply the park brake and block the wheels.
- Disconnect the electrical connector from the brake fluid level sensor.
- Disconnect the brake pipes from the master cylinder.
Important: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
- Plug the open brake pipe ends.
- Remove the master cylinder mounting nuts.
- Remove the master cylinder from the vehicle.
- Remove the master cylinder reservoir. Refer to
Master Cylinder Reservoir Replacement
.
Installation Procedure
- Install the master cylinder reservoir. Refer to
Master Cylinder Reservoir Replacement
.
- Bench bleed the master cylinder. Refer to
Master Cylinder Bench Bleeding
.
Important: If the seal is missing or damaged, replace the seal. Be sure that the O-ring is seated against the master cylinder base, not in the groove.
- Install the O-ring seal to the master cylinder.
- Install the master cylinder to the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the master cylinder mounting nuts.
Tighten
Tighten the nuts to 36 N·m (27 lb ft).
- Remove the rubber cap or plug from the exposed brake pipe fitting ends.
- Connect the brake pipes.
Tighten
Tighten the fittings to 25 N·m (18 lb ft).
- Connect the electrical connector to the brake fluid level sensor.
- Bleed the hydraulic brake system. Refer to
Hydraulic Brake System Bleeding
.
- Release the park brake and unblock the wheels.