Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the inflatable restraint steering wheel module. Refer to
SIR Disabling and Enabling in SIR.
- Disconnect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Remove the steering wheel from the column. Refer to
Steering Wheel Replacement.
- Remove the gap hider. Refer to
Instrument Cluster Replacement in Instrument Panel, Gages, and Console.
- If tilt column, remove the tilt lever from the lower trim cover. Refer to
Tilt Lever Replacement.
Important: You must check for 2 pan head tapping screws (1,2) in the lower trim cover before removal.
- If necessary, remove the 2 pan head tapping screws (1,2) from the lower trim cover (3). Remove the lower trim cover (3).
If screws are not present in the lower trim cover, proceed to the next step.
- Gently unsnap the lower trim cover from the upper trim cover.
Important: You must check for 1 TORX® head screw (1) in the upper trim cover (2) before removal.
- If necessary, remove 1 TORX® head screw (1) from the upper trim cover (2).
If a screw is not present, remove the upper trim cover (2).
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
Important: If the snap on/off feature on the trim covers was damaged during the removal procedure, you MUST use screws for the installation procedure. If screws were present in the trim covers before the removal procedure, you MUST
use the screws during the installation procedure.
If there was not any damage done to the trim covers during the removal procedure and no screws were present, proceed to step 2.
- Install the upper trim cover (2) onto the steering column. Install 1 TORX® head screw (1) into the upper trim cover (2).
Tighten
Tighten the screw to 1.5 N·m (13 lb in).
Important: If column shift, the shift lever seal must be seated in the trim covers.
- Slide the shift lever seal down the shift lever.
- Gently snap the lower trim cover to the upper trim cover.
- If screws were not used in the installation procedure, proceed to step 6.
- Screw the 2 pan head tapping screws (1, 2) into the lower trim cover.
Tighten
Tighten the 2 pan head tapping screws to 3.5 N·m (31 lb in).
- If tilt column, install the tilt lever into the lower trim cover. Refer to
Tilt Lever Replacement.
- Install the gap hider. Refer to
Instrument Cluster Replacement In Instrument Panel, Gages, and Console.
- Install the steering wheel onto the steering column. Refer to
Steering Wheel Replacement
- Connect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Enable the inflatable restraint steering wheel module. Refer to
SIR Disabling and Enabling in SIR.