Removal Procedure
- Disconnect the negative battery cables. Refer to
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
in General Information. - Remove the oil level indicator tube bracket, nut and washer, at the exhaust manifold.
- Remove the oil level indicator tube.
- Remove the o-ring seal from the oil level indicator tube.
Installation Procedure
- Install the o-ring seal to the oil level indicator tube.
- Install the oil level indicator tube to the engine.
- Install the oil level indicator tube nut and washer.
- Connect the negative battery cables.
Tighten
Tighten the oil level indicator nut to 4 N·m (35 lb in).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
