Exhaust Manifold Replacement Right Side

1. Remove the exhaust pipe from the exhaust manifold. Refer to Catalytic Converter Replacement in Engine Exhaust.
2. Disconnect the oxygen sensor electrical connector.
3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Control.
4. Remove the bolt for the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .



5. Remove the exhaust manifold bolts.
6. Remove the exhaust manifold. Refer to Exhaust Manifold Removal (Right) .
7. Clean all sealing surfaces. Refer to Exhaust Manifold Clean and Inspect .

1. Install the exhaust manifold. Refer to Exhaust Manifold Installation (Right) .




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolt for the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .

Tighten
Tighten the bolt to 12 N·m (106 in lb).

3. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
4. Install the exhaust pipe to the exhaust manifold. Refer to Catalytic Converter Replacement in Engine Exhaust.
5. Connect the oxygen sensor electrical connector.

Exhaust Manifold Replacement Left Side

1. Remove the exhaust pipe from the exhaust manifold. Refer to Catalytic Converter Replacement in Engine Exhaust.
2. Disconnect the oxygen sensor electrical connector.



3. Disconnect the EGR inlet pipe from the exhaust manifold. Refer to Exhaust Gas Recirculation Valve Replacement in Engine Controls.



4. Remove the exhaust manifold bolts.
5. Remove the exhaust manifold. Refer to Exhaust Manifold Removal (Left) .
6. Clean all sealing surfaces. Refer to Exhaust Manifold Clean and Inspect .

1. Install the exhaust manifold. Refer to Exhaust Manifold Installation (Right) .



2. Connect the EGR inlet pipe to the manifold. Refer to Exhaust Gas Recirculation Valve Replacement in Engine Controls.
3. Install the exhaust pipe to the exhaust manifold. Refer to Catalytic Converter Replacement in Engine Exhaust.
4. Connect the oxygen sensor electrical connector.