Removal Procedure
- Drain the coolant from the radiator. Refer to
Cooling System Draining and Filling
.
- Remove the compressor. Refer to
Air Conditioning Compressor Replacement
in HVAC Systems with A/C - Manual.
- Remove the crankcase depression regulator valve.
- Remove the generator upper bracket. Refer to
Generator Replacement
in Engine Electrical.
- Disconnect the bypass hose.
- Disconnect the upper radiator hose. Refer to
Radiator Hose Replacement
.
- Disconnect the heater hose. Refer to
Heater Hoses Replacement
in HVAC Systems with A/C - Manual.
- Remove the studs and the
bolts.
- Remove the coolant crossover housing assembly (4) from the vehicle.
The thermostats (2) and the coolant outlet (1) attach to the crossover housing
assembly, along with the thermostat bypass nipple (5).
- Clean the crossover housing sealing surfaces.
Installation Procedure
- Install the new gaskets
(3).
- Install the coolant crossover housing assembly (4).
- Install the studs and the bolts.
Tighten
Tighten the studs and the bolts to 42 N·m (31 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Connect the heater hose. Refer to
Heater Hoses Replacement
in HVAC Systems with A/C - Manual.
- Connect the upper radiator hose. Refer to
Radiator Hose Replacement
.
- Connect the bypass hose.
- Install the generator upper bracket. Refer to
Generator Replacement
in Engine Mechanical.
- Install the compressor. Refer to
Air Conditioning Compressor Replacement
in HVAC Systems with A/C - Manual.
- Install the crankcase depression regulator valve.
- Fill the cooling system with coolant. Refer to
Cooling System Draining and Filling
.
- Start the engine. Run the engine, with the surge tank cap removed,
until the upper radiator hose becomes hot. This indicates that the thermostat
is open.
- Attach the surge tank cap to the surge tank. Make sure that the
cap arrows line up with the overflow tube.
- Inspect the cooling system for leaks.