Notice: Do not run the engine without the oil pump drive in place. This will cause extensive engine damage.

1. Disconnect the battery negative cables from the batteries. Refer to Battery Replacement in Engine Electrical.
2. Remove the upper intake manifold cover.
3. Remove the fuel filter from the lower intake manifold and lay to the side secure out of the way.



4. Tie the engine wiring harness extension harness assembly out of the way.



5. Remove the retaining clamp and bolt from the oil pump drive gear.



6. Remove the oil pump drive gear from the engine block.
7. Remove the oil pump drive gear O-ring.

Important: When replacing the oil pump drive gear, always use a new O-ring.

1. Coat the new O-ring with clean engine oil before install it on the oil pump drive gear.
2. Install the O-ring on the oil pump drive gear.

Important: Do not force the oil pump drive gear into place. The oil pump drive gear should slide into place with slight resistance. Clean the bore and apply a small amount of clean engine oil before installing the oil pump drive gear.




3. Install the oil pump drive gear into the engine block.

•	Index the drive with the camshaft gear.

•	Make sure the oil pump drive gear is fully seated before installing the retaining clamp and bolt.





Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the retaining clamp bolt to the engine block.

Tighten
Tighten the bolt to 42 N·m(31 lb ft).

5. Untie the engine wiring harness extension harness assembly and reposition.



6. Repostion the fuel filter on the lower intake manifold.



7. Install the upper intake manifold cover from the engine.
8. Connect the battery negative cables to the batteries. Refer to Battery Replacement in Engine Electrical.