Ignition Coil and Ignition Coil Module Replacement HVS

1. Remove the air cleaner assembly.
2. Disconnect the electrical connectors.
3. Remove the ignition coil wire to the distributor.



4. Remove the studs holding the bracket and the ignition coil to the intake manifold.
5. Remove the bracket and the ignition coil.
6. Drill and punch out the two rivets holding the ignition coil to the bracket.
7. Remove the ignition coil from the bracket.

A replacement ignition coil kit comes with two screws in order to attach the ignition coil to the bracket.

1. Install the ignition coil to the bracket with the two screws.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




2. Install the ignition coil and the bracket to the intake manifold with studs.

Tighten
Tighten the studs to 11 N·m (8 lb ft).

3. Install the ignition coil wire.
4. Install the electrical connectors.
5. Install the air cleaner assembly.

Ignition Coil and Ignition Coil Module Replacement VIN J

1. Remove the air cleaner assembly.
2. In order to gain access to the ignition coil, relocate the engine wiring harness at the left rear side of the engine.
3. Disconnect the electrical connectors for the ignition coil and the ICM.



4. Remove the bolts retaining the coil to the intake manifold.
5. Remove the ignition coil.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




1. Install the ignition coil and the bolts to the intake manifold.

Tighten
Tighten the bolts to 27 N·m (22 lb in).

2. Connect the electrical connectors for the ignition coil and the ICM.
3. Relocate the engine wiring harness at the left rear side of the engine.



4. Install the air cleaner assembly.