Important: If the halfshaft boot cover will be reused, do not damage the halfshaft boot cover while removing the clamps.
J 41187 Band-it Type Tool
Important: Tighten the boot cover clamp (1) as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the cover to slide upon the joint. This causes shortened service life.
• | K10 = 180 degrees |
• | K20/K30 = 90 degrees |
Important: Be sure that the inboard tab of the halfshaft boot cover (1) is 180 degrees opposite the outboard tab of the halfshaft boot cover (1) before proceeding.
Important: Tighten the boot cover clamp (1) as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the cover to slide upon the joint. This causes shortened service life.