Parking Brake Cable Replacement Front Cable

1. Release the parking brake.
2. Raise the vehicle and support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.



3. Loosen the adjusting nut at the equalizer (2).



4. Remove the connector (1).



5. Disconnect the cable (2) from the parking brake lever (1).



6. Bend in the retaining fingers at the frame bracket.



7. Disconnect the front cable (2).

1. Install the front cable (2).
2. Connect the cable (2) to the parking brake lever (1).



3. Make sure all the retaining fingers are through the hole.



4. Install the connector (1).
5. Adjust the front cable. Refer to Park Brake Cable Service/Adjustment .

Parking Brake Cable Replacement Rear Cable - 1Ton

1. Release the parking brake.
2. Raise the vehicle and support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle .



3. Loosen the nut at the equalizer.
4. Remove the connector.
5. Disconnect the rear brake assembly. Refer to Brake Drum Replacement .
6. Bend the retaining fingers at the backing plate.
7. Disconnect the cable.

1. Install the cable.
2. Connect the cable end into the backing plate. Ensure all retaining fingers are completely through the backing plate.
3. Connect the rear brake assembly. Refer to Brake Drum Replacement .
4. Install the connector.
5. Adjust the rear cable. Refer to Park Brake Cable Service/Adjustment .

Parking Brake Cable Replacement Parking Brake Cable

1. Release the parking brake.
2. Raise the vehicle and support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.



3. Remove the cotter pin (4).
4. Remove the clevis pin (3).
5. Disconnect the clevis (5) from the cable.
6. Disconnect the grommet (6) from the bracket.



7. Remove the cable (4) from the clip (5).
8. Disconnect the grommet (3) from the body (6).



9. Disconnect the retaining fingers (1) from the lever.
10. Remove the cable assembly.

1. Install the cable assembly (4).



2. Connect the retaining fingers (1) to the parking brake lever.
3. Connect the grommet (3) to the body (6).



4. Connect the grommet (6) to the bracket.



5. Install the cable (4) into the clip (5).



6. Connect the clevis (5) to the park brake cable. Ensure the retaining fingers are tight.
7. Adjust the parking brake cable. Refer to Park Brake Cable Service/Adjustment .
8. Lower the vehicle.

Parking Brake Cable Replacement Rear Cable - 1/2 and 3/4 Ton

1. Release the parking brake.
2. Raise the vehicle and support the vehicle with safety stands.
3. Loosen the nut at the equalizer.



4. Remove the connector.
5. Disconnect the rear brake assembly. Refer to Brake Drum Replacement in Drum Brakes.
6. Bend the retaining fingers at the backing plate.
7. Disconnect the cable.

1. Install the cable.
2. Connect the cable end into the backing plate. Ensure all retaining fingers are completely through the backing plate.
3. Connect the rear brake assembly. Refer to Brake Drum Replacement in Drum Brakes.
4. Install the connector.
5. Adjust the rear cable. Refer to Park Brake Cable Service/Adjustment .