Removal Procedure
- Disconnect the negative battery cable.
- Disable the SIR. Refer to Disabling the SIR System in SIR.
- Remove the electrical connector from the stoplamp switch.
- Remove the pushrod retainer.
- Remove the stoplamp switch.
- Remove the pushrod.
- Remove the nut.
- Remove the brake pedal bolt.
- Remove the bushings and the spacer.
- Remove the brake pedal.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the brake pedal.
- Install the spacer and the bushings.
- Install the bolt and nut.
- Install the pushrod.
- Install the stoplamp switch.
- Install the pushrod retainer.
- Install the electrical connector on the stoplamp switch.
- Enable the SIR. Refer to Enabling the SIR System in SIR.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nut to 47 N·m (35 lb ft).
