Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle Column Shift

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.

Tighten
Tighten the screws to 4.7 N·m (42 lb in).




2. Slide the 2 connectors of the turn signal and multifunction switch assembly (2) onto the bulk head connector (1).
3. Install the upper tilt head components. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .

Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle Floor Shift

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.

Tighten
Tighten the screws to 4.7 N·m (42 lb in).




2. Slide the 2 connectors of the turn signal and multifunction switch assembly (2) onto the bulk head connector (1).
3. Install the upper tilt head components. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .