Removal Procedure
- Disconnect the negative battery cable.
- Remove the knee bolster. Refer to Knee Bolster Replacement in Interior Trim.
- Remove the instrument panel (IP) auxiliary storage compartment, if equipped.
- Remove the remote CD player, if equipped.
- Remove the ashtray. Refer to Ashtray Replacement in Instrument Panel, Gauges and Console.
- Push on the clips behind the auxiliary storage compartment or the remote CD player.
- Disconnect the electrical connector.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Pull down in order to release the module.
Installation Procedure
- Connect the electrical connector.
- Slide in the rear tabs of the module.
- Install the ashtray. Refer to Ashtray Replacement in Instrument Panel, Gauges and Console.
- Install the IP auxiliary storage compartment, if equipped.
- Install the remote CD player, if equipped.
- Install the knee bolster. Refer to Knee Bolster Replacement in Interior Trim.
- Connect the negative battery cable.
- Reprogram the EVO/Passlock™ module. Refer to Programming Replacement Keys, Ignition Cylinder, or Powertrain Control Module .
Push up in order to engage the module.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
