Removal Procedure
- Make sure the headlamp switch is in the OFF position.
- Remove the bulbs from the headlamp capsules by reaching from the engine compartment and by twisting the bulb counterclockwise.
- Remove the 2 long screws from the top of the radiator support.
- Pull forward the headlamp assembly (3).
- Disconnect the electrical connector (2) from the burned out bulb assembly (1).
Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly
could cause it to shatter into flying glass fragments. To help avoid personal
injury:
• Turn off the lamp switch and allow the bulb to cool before changing
the bulb. • Leave the lamp switch OFF until the bulb change is complete. • Always wear eye protection when changing a halogen bulb. • Handle the bulb only by its base. Avoid touching the glass. • Keep dirt and moisture off the bulb. • Properly dispose of the used bulb. • Keep halogen bulbs out of the reach of children.
Notice: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when the bulb is turned on. If either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the bulb dry.
Installation Procedure
- Install the new bulb assembly (1) into the headlamp assembly (3).
- Seat the bulb assembly with the connector facing down.
- Connect the electrical connector (2) to the bulb assembly.
- Install the headlamp assembly.
- Install the 2 long screws through the top of the radiator support.
- Tighten the screws.
Important:
• Replace a high beam bulb with another high beam bulb. The high
beam bulb has a red gasket. • Replace a low beam bulb with another low beam bulb. The low beam
bulb has a gray tip and a yellow gasket at the base.
Twist clockwise the bulb assembly.
