GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 348761  Size: SH
  1. Disconnect the electrial connector from the wiper motor.
  2. Remove the three screws and the wiper motor cover.
  3. Remove the module from the wiper motor.

Installation Procedure


    Object Number: 348761  Size: SH
  1. Install the module in the wiper motor.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the wiper motor cover with the three screws.
  4. Tighten
    Tighten the three screws to 2.6 N·m (23 lb in).

  5. Connect the electrial connector to the wiper motor.